Honda XL200 2001 Shop Manual page 107

CLUTCH/GEARSHIFT LINKAGE
Remove the clutch lifter guide.
Remove the clutch bolts, clutch lifter plate and clutch spring.
NOTE
• Loosen the bolts a crisscross pattern in 2-3 steps.
Install the clutch center holder and remove the clutch lock nut.
TOOLS:
Clutch center holder
Lock nut wrench, 20 x 24 mm
Extension bar
Remove the following:
– Washer
– Clutch center
– Clutch discs
– Clutch plates
– Pressure plate
Remove the spline washer, clutch outer and clutch outer guide.
Remove the primary drive gear and woodruff key from the
crankshaft.
NOTE
• Do not lose the woodruff key.
8 -4
BOLT
LIFTER GUIDE
CLUTCH CENTER HOLDER
EXTENSION BAR
SPLINE WASHER
CLUTCH OUTER GUIDE
PRIMARY DRIVE GEAR
WOODRUFF KEY
XL2 0 0
SPRING
LIFTER PLATE
LOCK NUT WRENCH
CLUTCH OUTER