Honda XL200 2001 Shop Manual page 151

XL2 0 0
Apply a light coating of grease to the throttle pipe sliding surface
of handlebar and throttle cable end.
Install the throttle grip on the handlebar.
Connect the throttle cable end to the throttle pipe.
Install the throttle cable guide.
Install the screws and tighten the forward screw first, then the
rear screw.
Place the front master cylinder on the handlebar and install the
master cylinder holder with its "UP" mark facing up.
Align the end of the holder with the punch mark on the handlebar.
Tighten the upper bolt first, then the lower bolt.
FRONT WHEEL/SUSPENSION/STEERING
THROTTLE PIPE
THROTTLE CABLE
CABLE GUIDE
SCREWS
MASTER CYLINDER HOLDER
PUNCH MARK
BOLT
"UP" MARK
1 1 -5