Honda XL200 2001 Shop Manual page 89

CYLINDER HEAD/VALVES
Apply oil to the cam lobes and camshaft bearings.
Install the camshaft in the cylinder head, positioning the cam
lobes down as shown.
Pour fresh oil into the oil pocket in the cylinder head until the
cams are submerged.
Apply sealant to the mating surface of the cylinder head cover.
h
• Do not apply sealant to the oil passage.
Install the head cover onto the cylinder head.
Apply oil to the cap nut threads.
Install the new sealing washers/cap nuts and flange bolts.
Tighten the cap nut in a crisscross pattern in 2-3 steps.
TORQUE: 27 N.m (2.7 kg.m, 20 ft-lb)
Tighten the flange bolts and setting bolt in a gradual crisscross
pattern.
TORQUE: 10 N.m (1.0 kg.m, 7 ft-lb)
Align the "T" mark on the flywheel with the index mark on the left
crankcase cover by turning the crankshaft counterclockwise.
6 -1 6
CAMSHAFT
HEAD COVER
SEALANT
CAP NUT/WASHER
BOLT
(1) INDEX MARK
XL2 0 0
(2) "T" MARK