Honda XL200 2001 Shop Manual page 180

XL2 0 0
Install the brake cam seat, aligning its tabs with the projection of
the brake panel.
Apply grease to the sliding surfaces of the anchor pin and brake
cam and install the brake cam.
t
Avoid getting grease on the inside of the brake drum or
braking power will be reduced. Clean the inside of the brake
panel thoroughly
Install the wear indicator plate aligning the wide tooth on the
indicator plate with the wide groove on the brake cam.
Install the brake arm aligning the punch marks on the brake arm
and cam.
Install the pinch bolt and nut, tighten the nut.
TORQUE: 10 N.m (1.0 Kg.m, 7 ft-lb)
Install the brake shoes and springs.
t
• A contaminated brake drum or shoe reduces stopping
power. Discard contaminated shoes and clean a
contaminated drum with a high quality brake degreasing
agent.
NOTE
If the brake shoes are reused, be sure to reassemble them in
their original positions.
Install the brake panel on the rear wheel and install the wheel.
Adjust the rear brake.
REAR WHEEL/SUSPENSION
ALIGN INDICATOR PLATE
BRAKE CAM SEAT
BRAKE ARM
ALIGN BOLT
SHOE
SPRING
CAM SEAT
ALIGN
NUT
1 2 -9