Regulator/Rectifier - Honda XL200 2001 Shop Manual

BATTERY/CHARGING SYSTEM

REGULATOR/RECTIFIER

SYSTEM INSPECTION
Remove the fuel tank.
Disconnect the regulator/rectifier 4P connector.
Check the connector for loose or corroded terminals.
Measure the following between the connector terminals of the
wire harness side.
Item
Battery charging
line And Green (–)
Ground line
Body ground
Charging coil
line
Lighting coil line
If any one item does not meet the standard, test the individual
component and replace the part, or repair open or short circuit in
the wire harness, or poor ground.
If the above items are all OK, check the regulator/rectifier.
Provided the circuit on the wire harness side is normal and there
are no loose connections at the connector, inspect the
regulator/rectifier unit by measuring the resistance between the
terminals.
Replace the regulator/rectifier unit if the resistance value
between the terminal is abnormal.
1 5 -6
Terminals Standard
Red (+) Battery voltage
should resister
Green and Continuity
Pink and 0,1–1,0Ω
Yellow (20° C/68° F)
Yellow and 0,1–0,8Ω
Green (20° C/68° F)
REGULATOR/RECTIFIER
CONNECTOR
CONNECTOR
XL2 0 0