Carburetor Idle Speed - Honda XL200 2001 Shop Manual

XL2 0 0
Check the valve clearance by inserting a feeler gauge between
the adjusting screw and valve stem.
Valve clearance: IN/EX: 0.10±0.02 mm (0.004 ± 0.0008 in)
Adjust by loosening the lock nut and turning the adjusting screw
until there is slight drag on the feeler gauge.
Hold the adjusting screw and tighten the lock nut.
Recheck the valve clearances.
Check the O-ring is in good condition, install the valve adjuster
covers.
Check the O-rings is in good condition istall the timing hole cap.

CARBURETOR IDLE SPEED

NOTE
• Inspect and adjust the idle speed after all engine
maintenance items have been performed and are within the
specifications.
• The engine must be warm for accurate idle speed
inspection and adjustment.
Shift the transmission into neutral and support the motorcycle
level ground.
Warm up the engine for about ten minutes and connect a
tachometer.
Turn the throttle stop screw as required to obtain the specified
idle speed.
Idle speed: 1.400 ± 100 rpm.
FEELER GAUGE
VALVE ADJUSTER
VALVE ADJUSTER WRENCH, 8 X 9 mm
O-RING
THROTTLE STOP SCREW
MAINTENANCE
3 -7