REAR WHEEL/SUSPENSION
Pack all new bearing cavities with grease.
Drive the left bearing in using the following tools.
NOTE
Install the bearing with its sealed side facing out.
TOOLS
Driver
Attachment,, 42x47 mm
Pilot, 15 mm
Install the distance collar.
Drive the new bearing in using the same tools.
Apply grease to the lip of the dust seal and install it.
Install the drive sprocket and secure it with the snap ring
securely.
Install the left side collar.
INSTALLATION
Install the brake panel.
Place the slot in the brake panel over the tang on the swingarm,
and then install the drive chain onto the sprocket.
Install the following:
– drive chain adjusters
– drive chain adjusting plates
– axle from the left side
– axle nut
Adjust the drive chain slack (page 3-9).
Tighten the axle nut to the specified torque.
Torque: 90 N.m (9.0 kg.m, 64 ft-lb)
1 2 -6
DRIVER
ATTACHMENT/PILOT
DRIVEN SPROCKET
DUST SEAL
XL2 0 0
ATTACHMENT/PILOT
COLLAR
SNAP RING