Honda XL200 2001 Shop Manual page 53

FUEL SYSTEM
– Main jet/jet needle holder/jet needle
– Slow jet
– Pilot screw
NOTE
• Do not try to remove the float valve seat from the carburetor
body.
• Before removing the pilot screw, record the number of turns
until it seats lightly. Use this as a reference for reinstallation.
• Remove the jet needle by pressing it out from the throttle
valve side carefully.
h
• Damaged the pilot screw seat will occur if the screw is
tightened against the seat.
Clean the jets with compressed air.
Inspect the jets for wear or damaged and replace if necessary.
Remove the spring and link arm.
Remove the screws and the set plate from the throttle valve.
4 -6
MAIN JET/JET NEEDLE HOLDER/JET NEEDLE
SLOW JET
SPRING
LINK ARM
SCREWS
THROTTLE VALVE
XL2 0 0
PILOT SCREW
SET PLATE