Setting Up The Sewing Unit; Aligning The Machine - Dürkopp Adler 806N-111 Operating Instructions Manual

Setup
Removing the transport lock from the power cable and the pedal
The power cable and pedal are already assembled to the machine.
Remove both parts from the machinery space behind the control. To do
so, remove the rear covers below the table level ( p. 110).

7.4 Setting up the sewing unit

7.4.1 Aligning the machine

Important
To prevent accidents the weight of the sewing unit must be evenly
distributed over the 4 adjustable feet.
Fig. 85: Aligning the machine
(1) - Adjustable foot
To align the machine:
1. Place a spirit level on the frame in order to align the machine level
2. Loosen the counternut (2).
3. Turn the adjustable foot (1) until it reaches the correct height.
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
WARNING
Risk of injury due to a lack of specialist
knowledge!
Lack of specialist knowledge can result in serious
injuries when setting up the machine.
Allow ONLY trained personnel to set up the
machine.
(e.g. at the rear by removing the rear bottom covers ( p. 110)).
②
①
(2) - Counternut
117