Initiating A Change Of Shape; User Interface 2 - Dürkopp Adler 806N-111 Operating Instructions Manual

Programming

5.5.7 Initiating a change of shape

To initiate a change of shape:
1. Press the Change shape button
2. Change the shaping assembly ( p. 40).

5.6 User interface 2

Fig. 70: User interface 2
Settings on user interface 2 can only be performed between two sewing
cycles. User interface 2 cannot be accessed when the machine is active.
Activated buttons are highlighted in green.
Some of the settings available on user interface 2 are additional equip-
ment. These buttons are still present when the additional equipment is not
present but are without function and do not change their appearance.
To navigate to user interface 2:
1. Navigate to user interface 1 ( p. 74).
2. Press the Global parameters button
 You are returned to user interface 2.
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
.
.
85