Dürkopp Adler 806N-111 Operating Instructions Manual page 116

2. Pull the cover upwards.
3. Insert the cover upwards into the guide hooks.
 The cover is locked in place by the springs on the lower guide hooks.
4. Fit the plate.
5. Fasten the plate with the screws.
To assemble the cover on the left side (2):
1. Insert the cover downwards into the guide hooks.
2. Pull the cover upwards.
3. Insert the cover upwards into the guide hooks.
 The cover is locked in place by the springs on the guide hooks.
4. Slide the retaining bar into the guide.
5. Fasten the screws on the retaining bar.
To assemble the covers on the rear (10):
1. Insert the cover downwards into the guide hooks.
2. Pull the cover upwards.
3. Insert the cover upwards into the guide hooks.
 The cover is locked in place by the springs on the guide hooks.
To assemble the cover at the front left (4):
1. Hang the cover in place.
To assemble the cover at the front right (7):
1. Insert the cover downwards into the guide hooks.
2. Pull the cover upwards.
3. Insert the cover upwards into the guide hooks.
4. Release the screw using a hex key through the front middle hole.
To assemble the stacker cover (8):
1. Pivot the stacker away from the machine.
2. Insert the cover from above.
114
Cover - Left side (2)
Covers on the rear (10)
Cover - Front left (4)
Cover - Front right (7)
Cover - Stacker (8)
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
Setup