Errors In Sewing Process - Dürkopp Adler 806N-111 Operating Instructions Manual

Troubleshooting

11.3 Errors in sewing process

Error
Thread broken
Bobbin empty
no seam program can
be selected
Needle thread monitor
signals an error
The stacker is not
stacking
Pocket blank is not
folded
Machine works only
step by step
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
Possible causes
• Reflector strips on the
rear side of the transfer
plate are damaged or
incomplete
• Code on the transfer
plate does not match the
desired seam program
• Light sensor for reading
the code is soiled
Needle thread broken
Stacker is not active
Sewing without edge
folding is active
Work step-by-step mode is
active
Remedy
• Thread needle thread  p. 26
• Continue or cancel sewing
 p. 51
insert new hook thread bobbin
 p. 32
• Replace or re-attach the
reflector strips
• Change the shaping assembly
 p. 40
• install new seam program
• Insert transfer plate and refer-
ence machine again
Thread needle thread  p. 26
Activate stacker  p. 90
Deactivate sewing without edge
folding  p. 87
Deactivate Work step-by-step
mode  p. 86
133