Connecting The Sewing Light Transformer To The Da321G Control Unit - Dürkopp Adler 667 Operating Instuructions

4.5.1

Connecting the sewing light transformer to the DA321G control unit

2
6
Fig. 20
16
1
5
– Loosen the 4 screws on the front plate of the control unit.
– Remove the front plate.
– Push the cable from the back through the cable duct 1 into the control
unit.
– Remove the black rubber grommet 2.
– Pierce the round opening of the rubber grommet with a screwdriver.
– Guide the cable of the sewing light transformer through the resulting
opening in the rubber grommet.
– Insert the rubber grommet again.
– With a small screwdriver press on the terminal openings 4 and 3 to open
the terminals 5 and 6.
– Connect the blue cable to terminal 6 and the brown cable to terminal 5.
– Fasten the front plate with the 4 screws again.
6
5
Fig. 21
3
4