Table of Contents
Advertisement
Inspect the machine while in use for any externally visible damage.
Operation
Stop working if you notice any changes to the machine. Report any chang-
es to your supervisor. Do not use a damaged machine any further.
Safety equipment should not be removed or deactivated. If it is essential
Safety
equipment
to remove or deactivate safety equipment for a repair operation, it must be
assembled and put back into operation immediately afterward.
The safety equipment is located at the illustrated positions on the
machine:
Fig. 1: Safety equipment
(1) - Protective hood
(2) - EMERGENCY STOP button
The following safety equipment are mounted on the machine:
10
①
②
Figure
Designation
EMERGENCY
STOP button
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
③
(3) - Integrated EMERGENCY STOP
(4) - Metal bar
Purpose
The machine is immediately placed
in the EMERGENCY STOP state:
– The motors are braked and then
disconnected from the power.
– The cylinders are depressurized.
Safety
④
Advertisement
Table of Contents
