Changing The Hook Thread Bobbin (806N-121) - Dürkopp Adler 806N-111 Operating Instructions Manual

Fig. 18: Winding the bobbin thread (806N-111) (2)
(3) - Bolt
(4) - Bobbin
(5) - Winder lever
4. Insert the thread from the rear to the front through the left hole of the
5. Feed the thread from the front to the rear through the hole in the middle
6. Insert the thread from the rear to the front through the right hole of the
7. Guide the thread counterclockwise once completely around the bolt (6).
8. Guide the thread counterclockwise around the bolt (1).
9. Wind the thread several times clockwise around the bobbin.
 The thread is fastened to the bobbin.
10. Press the winder lever (5) against the bobbin.
11. Sew with the selected seam pattern.
 The bobbin thread is wound on.
 Winding is automatically stopped by the winder lever (5) when the
12. When the bobbin is full, cut the thread and remove the bobbin.

4.8 Changing the hook thread bobbin (806N-121)

Information
The number of stitches you can make with the hook thread depends on
the type of thread and the sewing material.
For the procedure used to estimate the approximate capacity, see
( p. 80).
The hook thread bobbin is fitted under the sewing material support surface.
32
③
guide (7).
of the guide (7).
guide (7).
bobbin is full.
④ ⑤
(6) - Bolt
(7) - Guide
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
Operation
⑦
⑥