Dürkopp Adler 806N-111 Operating Instructions Manual page 19

Machine description
A description of the function can be found in the table below in addition to
the figure and designation of the buttons
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
Button Designation
Stop button
Start button
Cancel button
Safe stop
EMERGENCY
STOP
Function
The stop button does not light up.
If you press the stop button, the machine
ends the current work step and comes to
a safe stop. The activities described in
 Chapter 5.8 Activities on the machine
can be performed safely.
The start button can light up or flash in
green. If the start button lights up, you
can start a procedure on the machine by
pressing button 1. If the start button
flashes, an error has to be eliminated or a
requirement met. Next, press button 1 to
resume the procedure.
The cancel button does not light up.
The current edge folding procedure is
stopped by pressing the cancel button.
The sewing procedure is resumed.
Safe stop is not a button, but a lamp
which lights up in white. The safe stop
lamp indicates that no working procedure
is active. The activities described in
 Chapter 5.8 Activities on the machine
can be performed safely.
The EMERGENCY STOP button does not
light up. The machine stops all procedures
and is disconnected from the power supply
if you press the EMERGENCY STOP
button. The EMERGENCY STOP button
must be reactivated after actuation in order
to resume work,  Chapter 5.10,
Emergency procedure.
17