Deactivating Safety Equipment - Dürkopp Adler 806N-111 Operating Instructions Manual

Operation
2. An EMERGENCY STOP is triggered automatically on the left side of
 The motors are immediately braked.
 The cylinders are depressurized.
 The sewing head stops in the current position.
 The operating terminal continues to be supplied with power.
 A message is displayed on the operating terminal.
Fig. 41: Activating safety equipment (2)
When the danger situation has passed and you can continue working, you
need to deactivate the safety equipment first. The machine can only be op-
erated normally after this has been performed.

4.15.2 Deactivating safety equipment

Deactivating the EMERGENCY STOP button
To deactivate the EMERGENCY STOP button:
1. Correct any disturbance or danger that may be present.
2. Turn the EMERGENCY STOP button counterclockwise until it jumps
 The control for the machine starts up and clicks once.
 Air is audibly applied to the moving parts.
 The safe stop light lights up.
 The EMERGENCY STOP message is still displayed on the operating
3. Press the Confirm button
 The Start screen is displayed on the operating terminal. The
4. Repeat the settings on user interface 1 and user interface 2 that were
5. Start a new sewing cycle ( p. 55).
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
the transfer frame if too much resistance is detected.
back to the initial position.
terminal.
machine remains in the Safe stop mode.
deleted by the EMERGENCY STOP.
to acknowledge the message.
53