Table of Contents
Advertisement
Operation
To change the hook thread bobbin:
1. Navigate to the user interface Bobbin menu ( p. 80).
The transfer carriage moves to the side.
2. Press the Stop button.
The machine comes to a safe stop.
The safe stop light lights up.
Fig. 19: Changing the hook thread bobbin (806N-121)
(1) - Slot
(2) - Bobbin case retainer
3. Grasp the bobbin capsule, which is located far to the rear and centrally
4. Lift the bobbin case retainer (2) on the bobbin capsule.
The bobbin capsule is no longer locked in place and can be removed.
5. Remove the bobbin capsule from the hook.
6. Remove the empty bobbin from the bobbin capsule.
7. Press the full bobbin into the bobbin capsule.
Proper setting
Pulling the thread to the left causes the bobbin to rotate clockwise.
8. Pull out the thread approx. 5 cm.
9. Grasp the bobbin capsule by bobbin case retainer (2) and place it into
The bobbin capsule locks into place with a noticeable click.
10. Enter the number of stitches on the user interface Bobbin menu.
11. Adopt the number of stitches for the bobbin counter ( p. 80).
Operating Instructions 806N-111/806N-121 - 04.0 - 12/2020
①
under the sewing material support surface.
the hook under the sewing material support surface.
③
②
(3) - Spring
33
Advertisement
Table of Contents
