Setting An Even Sewing Foot Stroke - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

Sewing feet

12.2 Setting an even sewing foot stroke

Fig. 44: Setting an even sewing foot stroke (1)
(1) - Presser foot
Proper setting
For sewing foot stroke 3, the presser foot (1) and feeding foot (2) are
raised by the same height.
To set an even sewing foot stroke:
1. Execute the service routine Stroke > Equal Stroke ( p. 14).
 The software is used to define the necessary presettings on the
2. Remove the arm cover ( p. 17).
Fig. 45: Setting the sewing foot stroke (2)
(1) - Presser foot
(2) - Feeding foot
3. Loosen the screw (3).
4. Lower the feeding foot (2) to a height of 3 mm above the throat plate.
5. Tighten the screw (3).
6. Check whether the presser foot (1) and the feeding foot (2) are raised
7. Finish the service routine.
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
①
machine.
①
to the same height.
If not, correct the setting.
(2) - Feeding foot
②
(3) - Screw
(4) - Lever
②
④
③
57