Table of Contents
Advertisement
Table 1-1. E22xxA Functional Test System Rack Specifications
Size
Dimension
0.75m
Exterior
Moving Access
Requirements
Ramp Requirements
Hallway and Door Width
Requirements
If the system cannot be
moved in the crate
Chapter 1
Height
Width
740mm (29.1in)
600mm (23.6in)
*The approximate weight of a fully-loaded system is 112 kilograms (248 pounds) excluding the
pallet and shipping crate. The pallet and shipping crate, together, weigh approximately 90
kilograms (200 pounds).
The system is shipped from the factory on one pallet in a plywood shipping
crate. The pallet may be too large to move directly to your system's
destination.
The rack has casters and will negotiate ramps with inclines up to 8 percent
before the leveling feet drag at the ramp transition.
Make sure that all doors, elevators and passageways leading to the system's
final location are large enough to allow passage of the crated system. The
crated system requires the use of a floor jack or fork lift to engage the pallet
and lift the crated system. The dimensions of the system crate including
pallet are 41 inches W x 42.5 inches L x 53.25 inches H.
Remove the system from the pallet in the receiving area and push it on the
rack casters to the final destination if obstacles or lack of space restrict
moving the crated system.
Note
The rack casters can only transition very small floor level changes or gaps.
An uncrating document (Agilent part number E2230-90025) is attached to
the outside of the crate and describes how to uncrate the system.
Depth
Outside of rack: 750mm (29.5in)
Including Express Connect, PC and
Power Supply overhangs: 850mm
(33.46in)
EIA
15 RU
Site Preparation
13
Advertisement
Table of Contents
