The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the

numbering used by the respective operating system, however.

This interface can only be used in Automation Runtime and is displayed as IF2 in Automation Studio / Automation Runtime. It is not a "PC interface" and

therefore not displayed in BIOS.

4.7.4.14.4 Shielding

For the interfaces on the 10-pin female connector, the shield of the interfaces can be connected to pin Shield (pin

2) of the female connector.

In addition, there is a functional ground connection on the interface cover of the system unit that can also be used

for the cable shields.

4.7.4.14.5 Driver support and firmware update

The driver is part of the Automation Runtime and the firmware is part of Automation Studio. The module is auto-

matically brought up to this level.

To update the firmware contained in Automation Studio, a hardware upgrade must be performed (see

Project management / Workspace / Upgrades in Automation Help).

Automation PC 3100 User's manual V 2.10