Usb Interfaces - B&R Automation PC 3100 User Manual

4.6.5 USB interfaces

APC3100 devices are equipped with a Universal Serial Bus 3.0 (USB 3.0) host controller with several USB ports.
There are 4 USB 3.0 interfaces routed externally and freely available for the user. An additional USB 2.0 interface
located inside the device.
Warning!
USB peripheral devices can be connected to the USB interfaces. Due to the variety of USB devices
available on the market, B&R cannot guarantee their functionality. The functionality of USB devices
available from B&R is ensured.
Caution!
Due to the general PC specification, this interface must be handled with the utmost care with regard
to EMC, cable routing, etc.
Standard
Variant
Quantity
Transfer rate
Current-carrying capacity
1)
Cable length
USB 2.0
USB 3.0
1) Each USB interface is protected by a maintenance-free "USB current-limiting switch" (max. 1 A).
A USB 2.0 interface is available internally for the Technology Guard. The system unit must be opened for replace-
ment or retrofitting.
Standard
Variant
Transfer rate
Current-carrying capacity
1)
USB5
Cable length
1) The USB interface is protected by a maintenance-free "USB current-limiting switch" (max. 0.5 A).
Automation PC 3100 User's manual V 2.10
USB1-4
USB 3.0
Type A, female
4
Low speed (1.5 Mbit/s)
Full speed (12 Mbit/s)
High speed (480 Mbit/s)
SuperSpeed (5 Gbit/s)
Max. 1 A per connection
Max. 5 m (without hub)
Max. 3 m (without hub)
-
USB5
USB 2.0
Type A, female
Low speed (1.5 Mbit/s)
Full speed (12 Mbit/s)
High speed (480 Mbit/s)
Max. 0.5 A
Internal for Technology Guard
-
Technical data
41