Installation; Drivers; Activation - B&R Automation PC 3100 User Manual

7.4.2.5 Installation

Windows 10 IoT Enterprise 2016 LTSB is preinstalled at B&R on a suitable data storage medium (64-bit: at least
20 GB). After the system has been switched on for the first time, it runs through the out-of-box experience (OOBE),
which allows different settings to be made (e.g. language, region, keyboard, computer name, username).
Windows 10 IoT Enterprise 2016 LTSB can be installed in UEFI or Legacy BIOS mode. In UEFI mode, the data
storage medium containing the Windows partition is formatted with a GUID Partition Table (GPT) file system. For
other drives, it is possible to use either the GPT or Master Boot Record (MBR) file format. A GPT drive can have
up to 128 partitions.
When backing up and restoring the installation, note that the GPT file system must be supported by the software
used.

7.4.2.6 Drivers

The operating system contains all drivers necessary for operation. If an older driver version is installed, the latest
version can be downloaded and installed from the B&R website (www.br-automation.com). It is important to ensure
that "Unified Write Filter (UWF)" is disabled.
Information:
Necessary drivers must be downloaded from the B&R website, not from manufacturer websites.

7.4.2.7 Activation

Windows 10 IoT Enterprise 2016 LTSB must be activated like its predecessor Windows 10 IoT Enterprise 2015
LTSB. This takes place at B&R.
The activation status can be checked in the Control Panel:
Activation carried out by B&R is supported by special B&R extensions in the operating system and theoretically not
lost when the hardware is changed (e.g. replacement of components in the event of repair) or when the system is
reinstalled, unlike Windows 10 IoT Enterprise 2015 LTSB (Microsoft reserves the right to make technical changes
without notice).
Information:
It is not required to enter a product key for activation.
Automation PC 3100 User's manual V 2.10
Figure 24: System properties
Software
197