Installing The Automation Pc; Procedure; Installation Information For Individual Deliveries / Individual Components - B&R Automation PC 3100 User Manual

5.1.1 Installing the Automation PC

The Automation PC 3100 is installed using the mounting holes on the mounting plate. The holes are designed for
M5 screws. The two M5 screws needed for this are not included in delivery.
For the exact position of the mounting holes, see section

5.1.1.1 Procedure

1. Provide the mounting surface with the necessary holes. For the exact position of the mounting holes, see
the drilling templates.
2. Install the B&R industrial PC with M5 screws.

5.1.2 Installation information for individual deliveries / individual components

Information:
If the APC3100 is not delivered as a complete system but as individual deliveries (or individual com-
ponents are installed afterward), it may be necessary to enable these components in BIOS. To do this,
open BIOS during system startup, load the BIOS default values and restore and save any customized
BIOS settings. For additional information, see section
be required for the following individual components:
• Interface option
• Graphics option
• Mass storage option
• Main memory (DDR4 SDRAM)
Automation PC 3100 User's manual V 2.10
ø 5.5
ø 11
Figure 3: Mounting hole
"Drilling template" on page
"UEFI BIOS options" on page
Installation and wiring
28.
135. This may
127