Ethernet Interfaces - B&R Automation PC 3100 User Manual

Technical data

4.6.4 Ethernet interfaces

The Ethernet controllers are routed externally via the
system unit.
Variant
Controller
ETH1
ETH2
Wiring
Transfer rate
Cable length
LED "Speed" (a)
Green
Orange (dark)
LED "Link" (b)
Orange (light)
1) Switching takes place automatically.
2) The 10 Mbit/s transfer rate / connection is only available if LED "Link" is active at the same time.
A special driver is required to operate the Ethernet controller. Drivers for approved operating systems are available
for download in the Downloads section of the B&R website (www.br-automation.com).
Information:
Necessary drivers must be downloaded from the B&R website, not from manufacturer websites.
40
ETH1, ETH2
RJ45, female
Intel I219
Intel I210
S/STP (Cat 5e)
10/100/1000 Mbit/s
Max. 100 m (min. Cat 5e)
On
100 Mbit/s
1000 Mbit/s
On
Link (a connection to an
Ethernet network exists)
1)
Off
10 Mbit/s
2)
-
Active
Blinking (data be-
ing transferred)
Automation PC 3100 User's manual V 2.10