Installing The Automation Panel 1000 With Retaining Clips - B&R PC 3100 User Manual

Installation and wiring

5.1.2 Installing the Automation Panel 1000 with retaining clips

The Panel PC 3100 with AP1000 panel is installed in the installation cutout using retaining clips. The number of
retaining clips depends on the panel.
The device must be installed on a flat, clean and burr-free surface since tightening screws on an uneven area can
result in damage to the display or the ingress of dust and water.
Required tools:
• 2.5 mm hex screwdriver
Notice!
All the included retaining clips and clamping blocks must be used during installation. Failure to do
so can result in damage to property due to loss of leak tightness between the device and housing
(pollution) or mechanical stress.
Procedure
1. Check whether the supplied mounting screws (1) are screwed into the retaining clips (2). If this is not the
case, then the mounting screws must be screwed into the retaining clips with a 2.5 mm hex screwdriver (A).
The mounting screws are only permitted to be screwed in to the point where they do not project beyond the
retaining clip (B).
2. Insert the device into the prepared installation cutout (see
3. Install the retaining clips on the device. To do this, insert all retaining clips into the recesses (marked with
orange circles) on the device.
210
The following AP1000 panels are installed with retain-
ing clips:
• 5AP11x0.101x-000
• 5AP11x0.121E-0x0
• 5AP1130.185C-000
A A
(1)
(2)
"Installation diagrams" on page
Panel PC 3100 panel mount device User's manual V 2.10
• 5AP1120.1043-000
• 5AP11x0.156x-00x
• 5AP1180.1043-000
B
32).