Avery Dennison ALS 204 Service And Installation Manual page 84

5 O
PERATION
5.2 T O
ANDEM
Settings in the functions menu -
syncronisation via Com1
Settings on: Menu >Submenu
INTERFACE PARA
Master and Slave
>EASYPLUGINTERPR
>
INTERFACE PARA
>COM1 PORT >
MACHINE SETUP >
Master MACHINE SETUP >
MACHINE SETUP >
Slave
[88] Required settings for master and slave for tandem synchroni-
sation via Com1.
PERATION
Function
Interface
Baud rate
No. of data bits
Parity
Stop bits
Data synch.
Tandem synchron.
Tandem Operation
Tandem Distance
Tandem Operation
Setting
not "Serial Com1" and not „Auto negotiation"
During tandem operation, Com1 is used for
communication between master and slave
machine. Therefore, the interface function
may not be set to „Auto negotiation" or to
„Serial Com1".
115 200
the same setting on both machines
"None"
"Serial Com1"
"Master" or „FlipFlop master"
Set the distance [89A] between the dispensing edg-
es of the master and slave.
"Slave"
[89]] Distance (A) between the dispensing edges of the two
labellers
84
ALS
20X
256
A