Avery Dennison ALS 204 Service And Installation Manual page 219

9 R
EPAIR
9.6 R
EWIND UNIT
Installing toothed belt:
Unscrew setscrews from pulley [310C], clean th-

reads and screw setscrews back in using Loctite
243. Install toothed belt and pulley before the th-
readlock hardens. Follow the threadlock manufactu-
rer's instructions for use.
Place the toothed belt over the motor pinion [310E].

Slide belt pulley onto dancer arm shaft and pull belt
onto belt pulley.
Turn the belt pulley in order to align one of the two

setscrews [310B] with the bevel in the dancer arm
shaft [310arrow].
Aligning belt pulley and toothed belt with motor pini-

on: The toothed belt must run in the centre of the
belt pulley and motor pinion.
Tighten setscrew [310B] to bevel, then tighten se-

cond setscrew.
Slide the motor [310D] until the toothed belt is taut.

Tighten 4 screws on the motor mount [310A].
Installing remaining parts:
Install casing rear wall.

Install support disc [311A]. When doing so, make

sure the assembly is correctly positioned: The side
with the indentations for the screw heads [311B]
faces outwards.
Install expanding mandrel and spool hub [311C].

E D
[310] Screw in one of the setscrews to meet the bevel at the end of
the shaft (pulley removed for illustration)
B
C
[311] Installing support disc, expanding mandrel and spool hub
219
ALS
20X
256
A
C B
A