Avery Dennison ALS 204 Service And Installation Manual page 172

8 F
AULT DESCRIPTION
8.1 T
YPES OF STATUS MESSAGES
Status Status text
5140 Rewinder control
5142 Dancer home pos. Homeposition of the rewinder dancer
5143 Rewinder Stop
5144 Rewinder Init
[196] List of error messages
Cause
Rewinder control
During problem-free operation,
the rewind unit dancer arm only
moves a minimal distance
around the "control position".
This is the position the dancer
arm takes up after initialisation
of the machine.
– Any force applied that moves the
dancer arm from its control position.
Example: The feed motor is blocked;
the backing paper is not conveyed
quickly enough; as a result the
dancer arm is pulled upwards.
Example: The backing paper is torn;
the dancer arm springs downwards.
arm could not be found.
– This message appears when the
dancer arm was held against its up-
per stop for more than two seconds.
Effect:
Power to the rewinder motor is
switched off, so that the rewinder can
be turned easily by hand.
This effect is helpful when in-
stalling a new label roll, because
the rewinder can be turned
easily.
The message has a couple of possible
causes:
– No label material inserted.
– Rewinder sensors are not or not pro-
perly connected.
– Sensor board position is faulty.
– Sensor defective.
172
Action to take
Press the key.

– This reinitialises the dancer arm con-
trol; the dancer arm moves back into
the control position.
Check, if the sensor board of the dan-

cer arm is connected properly.
Replace the sensor board.

Press the key to confirm the er-

ror message.
Insert material.

Check the connection. Connect the

sensors properly.
Correct the position of the sensor

board.
Exchange the sensor board.

ALS
20X
256