Avery Dennison ALS 204 Service And Installation Manual page 136

7 E
LECTRONICS
7.3 C
IRCUIT BOARDS
Installing the Applicator Interface
Requirements for the subsequent installation:
– ALS 20X or ALS 256
– Applicator Interface (Article no. A4455)
– Data cabel AI - CPU (Article no. A5001)
– Y supply cabel AI - CPU - Fan (Article no. A6805)
Tool:
– Hexagon socket driver 2,5 mm
Open the casing, see Ch. 9.3 Opening the casing

(page 186).
Remove two screws [137B] at the slot cover.

Remove slot cover.
Remove two screws [138A] at the board rack. Care-

fully pull out the board rack, until the connections at
the rear end of the CPU board are accessible.
Connect both cables to the CPU board and to the

Applicator Interface, see Ch. 7.1 Wiring Diagrams
(page 116).
Plug the Applicator Interface board onto the spread

sockets [139A]at the board rack.
Reinstall the board rack. While doing so, pay atten-

tion,
– that the noses at the rear end of the board rack fit
into the holes at the housing rear wall.
– not to wedge any cable between board rack and
housing.
Close the casing.

D
ESCRIPTION
136
B
A
[137] Slot cover (A) with mounting screws (B).
A
A
[138] Board rack with mounting screws (A) (LH version pictured).
A
[139] Plug the Applicator Interface onto the spread sockets (A)
on the board rack.
ALS
20X
256
B