9 R
EPAIR
9.5 F
EED UNIT
Removing toothed belt, belt pulleys and
motor
Open the casing - see Ch. 9.3 Opening the casing.
Loosen cable fastening [275B].
Remove 4 screws [276A] that secure motor driver
board in place.
Remove motor driver board [275C] and disconnect
all 4 plug connections [275D].
Loosen 3 screws on the motor [275A] to slacken the
toothed belt [275F].
Mark the installation positions of the pulley [275E]
on the shaft using a drawing point, for example.
Loosen the two setscrews on the pulley.
Remove toothed belt along with pulley.
Loosen 3 fastening screws on the motor and remo-
ve motor.
A
F
E
[275] Removing toothed belt and pulley
[276] Removing the fastening screws that secure the motor driver
board to the underside of the casing
208
B
D
A
ALS
20X
256
C