Avery Dennison ALS 204 Service And Installation Manual page 198

9 R
EPAIR
9.4 U
NWIND UNIT
Assembling dancer arm:
Clean the threads of the fastening screws [239D] for

the lever plate.
Fit washer disc [241B] [242B] to ball bearing [241A]

in dancer arm using grease.
Fit shaft with brake [239A] into dancer arm [239E].

Screw lever plate [239C] into place, securing screws

[239D] with Loctite 243. Follow the threadlock ma-
nufacturer's instructions for use.
Insert cable bushing with O-Ring [240A] from the in-

side of the dancer arm and screw tight.
Grease the brass bushing [242C] and guideway in

the control lever [242B] well. When doing so, ensure
brake linings remain free of grease.
Fix control lever in correct mounting position: Secu-

re the brass bushing in the marked position in the
dancer arm casing [242A].
[242] Mount control lever in its prescribed mounting position
[239] Assembly of brake, dancer arm casing and lever plate
[240] Unwind unit sensor with plug connection and cable bushing
A
C B
[241] Washer disc between ball bearing and lever plate
198
A
ALS
20X
256
B C D
E
A
A
B