Avery Dennison ALS 204 Service And Installation Manual page 212

9 R
EPAIR
9.5 F
EED UNIT
Support axle
To ensure the pressure roller functions correctly, the
support axle [287A] must be in a defined position:
– Groove [287arrow] in the support axle points ap-
prox. 45° downwards.
To set the position of the support axle:
Open the casing - see Ch. 9.3 Opening the casing.

Loosen cable fastening [288A] for motor leads.

Remove 4 screws [287B] that secure motor driver

board in place.
Remove motor driver board [288B] and disconnect

all 4 plug connections [288C].
Remove screw [289A].

Clean thread. Screw in the screw, using Loctite 243

Threadlock. Follow the threadlock manufacturer's
instructions for use.
Before threadlock hardens, rotate the support axle

to the correct position and tighten the screw.
Connect and install the motor driver board.

Fasten motor leads to housing with cable fastening.

Install casing rear wall.

[287] The groove in the support axle for the pressure roller points
downwards at 45°.
A
[288] Removing the motor driver board
[289] Retaining screw for support axle
212
A
C
A
ALS
20X
256
B
B