Avery Dennison ALS 204 Service And Installation Manual page 170

8 F
AULT DESCRIPTION
8.1 T
YPES OF STATUS MESSAGES
Status Status text
5001 No gap found
5002 Material end
5009 Start error
5019 Startsig. overrun
[196] List of error messages
Cause
– Material end, if no outer diameter
(OD) control is activated.
– The maximum limit for missing labels
was exceeded ( LABEL SETUP
bel tol. ).
– The machine is not correctly set for
MACHINE SETUP
the type of label (
bel sens. type
).
– Label length is not correctly set (
BEL SETUP > Label pitch ).
– Photoelectric label sensor is dirty.
– Photoelectric label sensor is incor-
rectly positioned.
– Photoelectric label sensor is not con-
nected correctly.
– Photoelectric label sensor is defec-
tive.
– Rotary encoder is not adjusted cor-
rectly.
– Material end (if the internal OD-con-
trol is activated).
– Refers to the standard start sensor
input (M12).
– The device received another start
signal while applying a label.
MACHINE SETUP >
– Prerequisite:
ror stop is set to "On" .
– Too high start signal frequency
caused start signal buffer overflow.
– Possible causes: Distance between
product sensor and dispensing edge
is too high and/or to high product
170
Action to take
Check the points listed above and

correct if necessary.
Press the

> Miss. la- ror message.
> La-
LA-
Insert new label roll.


Check the operation of the labeller;

increase distance between products
if required.
MACHINE SETUP >
Set

Start er-
"off".
Decrease distance between product

sensor and dispensing edge.
Decrease dispensing/conveyor

speed.
Increase product distance.

ALS
20X
256
key to confirm the er-
Start error stop
to