Signals For Plc Connection - Avery Dennison ALS 204 Service And Installation Manual

7 E
LECTRONICS
7.5 S I
IGNAL NTERFACE

Signals for PLC connection

7.5.6
Required setting:
SIGNAL INTERFACE > Interface mode
Signal name Function
Inhibit – Input
– If the signal is active, start sig-
nals at both signal interfaces
(standard and AI) are ignored.
Triggering via
ble.
– AI installed: alternatively, the
Inhibit input at the AI can be ac-
tivated (
TIVE INPUTS > Inhibit signal
appl.interf")
Warning In – Input
– An external warning status can
be signaled by OR-link at the
warning output
Error In – Input
– An external error status can be
signaled by OR-link at the error
output
Ready – Output
– Active in dispensing mode
– Not active in configuration mode
– I < 500 mA
out
Error – Output
– Signal active when an error
message appears on the opera-
tor panel display
– I < 500 mA
out
Dispense End – Output
– Signal that can be used to acti-
vate a secondary unit (e.g. a
printing unit). Signal length and
delay can be set via the function
menu
– I < 500 mA
out
Warning – Output
– Active, if a warning status
occurs (e. g. label roll diameter
below desired nominal value)
– I < 500 mA
out
1) I over all outputs < 1500 mA
max
D
ESCRIPTION
= „PLC signals".
-key is possi-
SIGNAL INTERFACE >AC-
= „Opt.
1)
1)
1)
1)
152
Inhibit A
1
Warning In A 2
Error In A
3
+24 V 4
Error
5
Ready
6
Dispense End 7
Warning 8
[162] Pin assignment D-Sub15 connector
Ready 4
GND 3
Error 2
[163] Pin assignment M12 socket (fem. connector; output sig-
nals). Matching connector: article no. A8144.
Error In A 6
GND 7
Inhibit K 1
[164] Pin assignment M12 socket (male connector; input sig-
nals). Matching connector: article no. A8145.
ALS
20X
256
Inhibit K
9
10 Warning In K
Error In K
11
12 GND
GND
13
14 GND
15 GND
5 GND
6 Dispense End
7 GND
1 GND
8 Warning
5 Error In K
4 Warning In A
3 Warning In K
2 Inhibit A
8 +24 V