Avery Dennison ALS 204 Service And Installation Manual page 61

4.1 F
UNCTION MENU
4.1 F
UNCTION MENU
Standalone: This mode is used for loading firmware
(see chap. "Loading Firmware" on page 101) or
configurations (see chap. "Saving/loading a
configuration" on page 110) from CF card.
Language function:
– Language of display text
– Settings: [German, English, French, Spanish, Dut-
ch, Danish, Italian, Polish, Turkish]
Access authoriz. function:
– Limits access to functions from the menu. Changes
only come into force the next time the machine is
switched on.
– Settings: [User auto start, Supervisor, User, "Power-
up code", "Deactivated"]
User auto start: Machine starts in user mode.
Supervisor: Activates password check when the
machine changes from offline mode to the
Valid keycodes:
parameter menu.
.
Production
User: Same as the "Supervisor" setting, except for
the valid keycodes.Valid keycodes: All
"Power-up code": Activates password check as
soon as machine is switched on. Once a valid
keycode has been entered, the machine switches to
Offline mode. The machine is then in either User,
Supervisor or Production mode, depending on
which keycode was entered.
"Deactivated": Password check deactivated
Mode Keycode
User - -
Supervisor - -
Production - -
[75] Valid keycodes
Mode Effect
Access to the
User
SERVICE DATA
Supervisor Access to all functions except produc-
tion functions (indicated in the over-
view)
Production Access to all functions
[76] Effects of the different modes
Supervisor,
-
- - -
- - - -
and
LABEL SETUP
menus
CAUTION!
Improper use of the special functions only
accessible in production mode can damage
the labeller or stop it from functioning.
Settings in production mode should only

be adjusted by a trained servicing techni-
cian.
Default values function:
– Settings: [Standard, "User defined"]
Standard: Calling the "Factory settings" parameter
sets all parameters to the values defined by the
manufacturer.
"User defined": All current parameter settings are
adopted as default values. Calling the "Factory
settings" function then restores these values – even
after loading new firmware.
Factory settings function:
– Settings: [Yes, No]
Yes: Restores all settings to factory settings
No: Has no effect
Store Parameters function
– Saves the settings of the functions to a file on the
CompactFlash card ("FORMATS\" directory)
– Settings: ["With adjust para", "Without adj. par"]
"With adjust para" Parameters that contain device-
specific settings are included in what is saved. The
names of the relevant parameters are marked with
a * in the text file.
Default file name:
„SETUPALL ALS xxx yy zzzzzzzzzzzzzzzz.FOR".
: Service
Application
: Parameters that contain
"Without adj. par"
device-specific settings are excluded from what
is saved.
Default file name:
„SETUP
ALS xxx yy zzzzzzzzzzzzzzzz
: Transferring settings to other
Application
devices (when device-specific settings should
not be overwritten).
xxx = Machine type, e. g. 306
yy = RH or LH
zzzzzzzzzzzzzzzz = Serial number of the
CPU board
61
ALS
20X
256
.FOR".