Avery Dennison ALS 204 Service And Installation Manual page 110

6 E
NHANCED
6.4 I
NTERFACE COMMANDS
The #!WARF command
Syntax:
#!WARF
– Returns the warning status
– Return format: „WARF01234567<LF>"; If a warning
is active, the appropriate bit is set in the return
string. If no warning is active, a „_" is returned
instead of a digit.
Example:
The warnings 0 and 4 are active.
Return string: „WARF0___4___<LF>"
The #!XM command
Syntax:
#!XMn#G
Generates a diagnose dump and sends it to an inter-
face or stores it in the Flash memory.
F
UNCTIONS
Bit Meaning
0 – New start signal during the dispensing ope-
ration, or
– Several missing labels on the web, which
can not be compensated.
2 Material low
4 The conveyor speed exceeded the max. speed
of the dispenser.
5 OD control sensor detected material end
6 Too many products between sensor and
dispensing edge (max. 8 products are allowed).
7 The rewinder is deactivated.
[111] Bits in the return string of #!WARF.
n = Meaning
-99 Diagnose dump is sent to the debug interface
(which normally is Com1) and is stored in the
Flash.
-100 Diagnose dump is sent to the active data inter-
face ( INTERFACE PARA >EASYPLUGINTERPR > In-
terface ) and is not stored in the Flash.
[112] Values for #!XM.
110
ALS
20X
256