Avery Dennison ALS 204 Service And Installation Manual page 179

9 R
EPAIR
9.1 T
ESTS
Sensor ID Name
00.08 APSF l.
(rotary encoder - length)
00.09 APSF s.
(rotary encoder - status)
00.10 OD-A
(Sensor for pressure roller)
00.11 OD-B
(Unwind unit sensor)
00.12 Matdiam
(OD sensor)
00.13 Dancer 1
00.14 Dancer 2
00.15 DancerR
(Position sensor for rewind
unit dancer arm)
00.16 PLC-IN
00.17 MotStat
00.19 Rewdiam
00.21 RewDanc
[197] Overview for the "MACHINE SETUP > Sensor Test"
Value Test
xxxx.xx m – "Mileage counter" for rotary encoder meas-
– max. value depends on diameter of meas-
– Begins again when pulse counter reaches
Designed for factory use only
Not used
1 or 0 Display must change between 1 and 0 when
the unwinder is turned.
xx.xx mm Displays the diameter of the material roll as
currently calculated
Not used
xxx yyy – xxx = Value of absolute dancer arm posi-
– yyy = State of the dancer arm light barriers:
00000xxx – Status display for the signal interface inputs
– The last three digits (xxx) show the status
– 1 = Signal present; 0 = no signal
Designed for factory use only
xxxmm – Displays the currently calculated material
– Diameter calculation requires at least 2 m
xx% – Shifting of the two dancer arm encoder sig-
– Can be used for encoder adjustment during
– Rated value: > 20%
179
uring wheel
uring wheel
its max value
tion (??? = dancer arm not initialized). The
difference between the positive and nega-
tive value in the respective end positions is
approx. 40.
0 = blocked; 1 = open
of the three inputs PLC_IN1, PLC_IN2 and
PLC_IN3
roll diameter.
of material feeding.
nals in %, related to period time.
machine production.
ALS
20X
256