HARDWARE INSTALLATION
Step 1. Connect Network Interfaces
Connect the device to a local network using any of the available
physical network interfaces. All interfaces are configured by default
to receive IPv4 addresses via DHCP and IPv6 addresses via
SLAAC.
Additionally, the device can be accessed from a computer or local
network via NET1 with a static IPv4 address as shown in
Model
Interface
1Gb Ethernet
NET1
10Gb Ethernet
NET3
Table: Default static interface connection
Firewall Zone
Network Interfaces
WAN
NET1
LAN
NET2
Table: Default firewall zones for interfaces
Step 2. Connect Serial Devices
Connect managed devices to the serial interfaces on the front of the unit.
Static Address
192.168.0.1/24
192.168.0.1/24
Figure: Network interfaces for CM8100
Table: Default static interface
connection.
4