Table of Contents
Advertisement
Get started with Connect EZ
2. Connect the twist-lock end of the power supply cord to the device.
3. Plug the other end of the power supply cord to a main power supply.
NEXT STEP: If you are performing the initial device set-up, proceed to the next step:
to site network using an Ethernet
Step 3: Connect to site network using an Ethernet LAN
This section explains how to connect to a site network using an Ethernet cable.
1. Connect one end of an Ethernet cable to your site network.
2. Connect the other end of the Ethernet cable to the Ethernet port on the Connect EZ. By
default a DHCP request will be sent to the local Ethernet network.
Note
If you do not have a DHCP server on your network, you can connect locally over 192.168.210.1.
See
Using the local web
NEXT STEP: If you are performing the initial device set-up, proceed to the next step:
the IP address using the Digi
Step 4: Discover the IP address using the Digi Navigator
You can use the
Digi Navigator
Note
If you don't have access to the Digi Navigator, you can use a manual method to discover the
IP address. See
Discover the device's IP address: Additional
1. To ensure that your computer and device are connected to each other and your local network,
make the following connections:
Connect the device to your computer with an Ethernet cable.
n
Connect the device to your local network with an Ethernet cable.
n
Connect your computer to your local network with an Ethernet cable.
n
2.
Download and install
3. Launch the Digi Navigator.
4. The tool discovers the Connect EZ devices that are powered on and connected to your
network. When the process is complete, a list of the devices appears.
Connected to a network: By default, the HTTPS service is enabled and used to find an
n
IP address for the Connect EZ. Other services can be enabled if needed from the Filters
section. See
Connected directly to a device or on a network with no DHCP server: In either of
n
these situations, a default IP address is assigned to the device. You can specify the
filters used to assign an IP address. See
device
5. Expand a device to display the IP address.
Digi Connect EZ Mini User Guide
LAN.
interface.
Navigator.
to quickly discover the IP address for the Connect EZ.
the Digi Navigator.
Services used to discover a device when connected to a
and
Assign a generic IP address to the
Step 3: Connect to site network using an Ethernet LAN
methods.
Use the autodiscovery protocol to discover a
device.
Step 3: Connect
Step 4: Discover
network.
20
Advertisement
Table of Contents
