Introduction
ConnectPort LTS 32
n
ConnectPort LTS 32 MEI
n
ConnectPort LTS 32 W
n
ConnectPort LTS 32 MEI W
n
Quick reference for configuring features
The following table shows common features that can be configured from the command line, and the
commands used to configure each feature. If you are viewing the PDF file of this document, click the
commands in the "Commands" column to go to the command descriptions.
Feature/Task
Alarms
Autoconnection
(automatically connect a
user to a server or network
device)
Configuration
management/administration
Display current configuration
settings in a device
Ethernet settings
Help on device commands
Host name for a device
(Specify a name for the
device)
IP address settings
Multiple Electrical Interface
(MEI)
Point to Point Protocol (PPP)
Port buffering
Port profiles: sets of
preconfigured serial-port
settings for a particular use
ConnectPort® LTS Command Reference
Commands
set alarm
set autoconnect
set serial
set tcpserial
Backup/restore a configuration from a TFTP server on the network:
backup
Update firmware:
boot
Reset configuration to factory defaults:
action=factory" (see boot)
Reboot the device:
boot
show
set ethernet
help and ?
set host
set network
set switches
set ppp
display buffers
set buffer
set profile
Quick reference for configuring features
revert
or
boot
6