Connected Via Ethernet - Only 840D Sl - Siemens SINUMERIK 840D sl Function Manual

H1: Manual travel and handwheel travel
4.8 Start-up: Handwheels
Machine data
MD11351 $MN_HANDWHEEL_MODULE[2]
MD11352 $MN_HANDWHEEL_INPUT[2]
MD11350 $MN_HANDWHEEL_SEGMENT[3]
MD11351 $MN_HANDWHEEL_MODULE[3]
MD11352 $MN_HANDWHEEL_INPUT[3]
MD11350 $MN_HANDWHEEL_SEGMENT[4]
MD11351 $MN_HANDWHEEL_MODULE[4]
MD11352 $MN_HANDWHEEL_INPUT[4]
MD11350 $MN_HANDWHEEL_SEGMENT[5]
MD11351 $MN_HANDWHEEL_MODULE[5]
MD11352 $MN_HANDWHEEL_INPUT[5]
Logical base addresses:
Machine data
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [0]
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [1]
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [4]
MD11353 $MN_HANDWHEEL_LOGIC_ADDRESS [5]
4.8.4

Connected via Ethernet - only 840D sl

Parameter setting
The parameters for handwheels connected via Ethernet modules, e.g. machine control panel
"MCP 483C IE", "HT 8", or "HT 2", are assigned in the following NC machine data:
● MD11350 $MN_HANDWHEEL_SEGMENT[< x - 1 >] = 7
● MD11351 $MN_HANDWHEEL_MODULE[< x - 1 >] = 1
● MD11352 $MN_HANDWHEEL_INPUT[< x - 1 >] = y
where x = 1, 2, 3, etc. (handwheel number in the NC)
322
When connected via Ethernet modules, the segment always has to be entered as 7
(Ethernet).
When connected via Ethernet modules, the module always has to be entered as 1.
where y = 1, 2, 3, etc. (handwheel interface at the Ethernet bus)
Value Description
2 Reference to logical base address of the handwheel slot of the
2nd MCP
1 1st handwheel in handwheel slot
4th handwheel in NCK
0 No handwheel parameterized
0 No handwheel parameterized
0 No handwheel parameterized
5th handwheel in NCK
5 Hardware segment: PROFIBUS
6 Reference to logical base address of the handwheel slot of the
3rd MCP
1 1st handwheel in handwheel slot
6th handwheel in NCK
5 Hardware segment: PROFIBUS
5 Reference to logical base address of the handwheel slot of the
4th MCP
2 2nd handwheel in handwheel slot
Value Description
288 Logical base address handwheel slot 1st MCP
304 Logical base address handwheel slot 2nd MCP
330 Logical base address handwheel slot 4th MCP
320 Logical base address handwheel slot 3rd MCP
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Extended Functions