Siemens SINUMERIK 840D sl Function Manual page 730

N4: Punching and nibbling - only 840D sl
10.3 Activation and deactivation
Screen form for high-speed input and output bits:
MD26004 $MC_NIBBLE_PUNCH_OUTMASK[0]
MD26004 $MC_NIBBLE_PUNCH_OUTMASK[1]
MD26006 $MC_NIBBLE_PUNCH_INMASK[0]
MD26006 $MC_NIBBLE_PUNCH_INMASK[1]
Automatically activated pre-initiation time
Dead times due to the reaction time of the punching unit can be minimized if the stroke can
be initiated before the interpolation window of the axes is reached. The reference time for
this is the interpolation end. The stroke is automatically initiated with G603 and delayed by
the set value in relation to the time that the end of interpolation is reached.
The delay time for stroke initiation can be adjusted in machine data:
MD26018 $MC_NIBBLE_PRE_START_TIME
Example:
With an IPO cycle of 5 ms, a stroke shall be released two cycles after reaching the
interpolation end:
⇒ MD26018 $MC_NIBBLE_PRE_START_TIME = 0.01 [s]
A pre-initiation time can also be programmed in setting data:
SD42402 $SC_NIBPUNCH_PRE_START_TIME
This setting takes effective only if MD26018 = 0 has been set.
Monitoring of the input signal
If the "stroke active" signal is fluctuating between strokes due to plunger overshoots, for
example, the message "undefined punching signal" can be also be output when interpolation
is stopped.
The message output is dependent on the setting in machine data:
MD26020 $MC_NIBBLE_SIGNAL_CHECK
MD26020 = 0
MD26020 = 1
Minimum period between two strokes
A minimum time interval between two consecutive strokes can be programmed in setting
data:
SD42404 $SC_MINTIME_BETWEEN_STROKES
730
No alarm
Alarm
First interface output bit
= 1 → Bit 1 SPIF1
Second interface output bit
= 2 → Bit 2 SPIF2
First interface input bit
= 1 → Bit 1 SPIF1
Second interface input bit
= 2 → Bit 2 SPIF2
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Extended Functions