System Support; Differences During Commissioning Between Sinumerik 840D Sl And Sinumerik 828D; Support Cu320 - Siemens SINUMERIK 840D sl Operating Manual

Create MyConfig - Expert

4.3 System support

4.3 System support
4.3.1 Differences during commissioning between SINUMERIK 840D sl and
SINUMERIK 828D
Overview
The following table shows the essential differences during configuration of packages between
SINUMERIK 840D sl and SINUMERIK 828D:
Replace PLC blocks
Set HW Config
The CMC installation folder under Sample\Install_828D_Systemsoftware\ contains the
1
template for an HW Config archive for 828D systems.
HW Config in the case of SINUMERIK 828D
Depending on the system, one of the greatest differences between the two control system
series is the hardware configuration. While the hardware for 840D sl systems can be configured
in great detail via system data blocks (SDBs), in the case of 828D systems possible hardware
configurations are pre-configured and can be set via NC machine data.
For package execution under Shield, however, the HW Config for both systems must be
specified equally on the "System configuration (Page 186)" dialog page.
The template in the CMC installation folder "828D-SDB-Template.ard" contains the necessary
machine data and can be used as a template:
● MD11240 $MN_PROFIBUS_SDB_NUMBER[n]
● MD11241 $MN_PROFIBUS_SDB_SELECT
The machine data must be set in accordance with the control system documentation. The
newly created Archiv *.ARD can then be used as an offline archive in the System
configuration (Page 186) dialog.
4.3.2

Support CU320

Below it is shown how the CU320 is supported in package configuring and package execution
by Create MyConfig.
136
SINUMERIK 840D sl
Yes
Yes,
via SDB archive
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
SINUMERIK 828D
Only data blocks
Restricted,
via special HW Config data class
archive)
1