Siemens SINUMERIK 840D sl Function Manual page 268

B4: Operation via PG/PC - only 840D sl
3.1 Brief description
Implementation Variant 2
Operator panel front and up to three NCUs The machine control panel is permanently
allocated to the NCU concerned.
Figure 3-2
Reference:
/FB2/ Function Manual, Extended Functions; Several Operator Panel Fronts and NCUs (B3)
Operator interfaces
The operator interfaces are described in the operating manuals for the operator panel fronts
used.
Reference:
/BA/ Operating Manual
/FBO/ Configuration of Operator Interface OP 030; BA, Operating Manual OP030
Restrictions
If operation via PG/PC is used in addition to an OP030 operator panel front, the conditions
relating to configuration and coordination described in /FB2/, B3, "Several operator panel
fronts and NCUs" must be observed.
Reference:
/FB2/ Function Manual, Extended Functions; Several Operator Panel Fronts and NCUs (B3)
268
Configuration m:n corresponds to 1:3
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Extended Functions