Assignment Of Oscillation And Infeed Axes Oscill; Definition Of Infeeds Posp - Siemens SINUMERIK 840D sl Function Manual

12.3.7

Assignment of oscillation and infeed axes OSCILL

Function
One or several infeed axes are assigned to the oscillation axis with command OSCILL.
Oscillation motion starts.
The PLC is informed of which axes have been assigned via the VDI interface. If the PLC is
controlling the oscillation axis, it must now also monitor the infeed axes and use the signals
for the infeed axes to generate the reactions on the oscillation axis via 2 stop bits of the
interface.
Application
The axes whose response has already been defined by synchronous conditions are
assigned to one another for activation of oscillation mode. The oscillation movement is
started.
Programming
OSCILL[oscillation axis] = (infeed axis1, infeed axis2, infeed axis3)
Infeed axis2 and infeed axis3 in brackets plus their delimiters can be omitted if they are not
required.
12.3.8

Definition of infeeds POSP

Function
The control receives the following data for the infeed axis:
● Total infeed
● Part infeed at reversal point/reversal point range
● Part infeed response at end
Application
This instruction must be given after activation of oscillation with OSCILL to inform the
controller of the required infeed values at the reversal points/reversal point ranges.
Extended Functions
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
P5: Oscillation - only 840D sl
12.3 Oscillation controlled by synchronized actions
831