Axis Transfer To Neutral State (Release) - Siemens SINUMERIK 840D sl Function Manual

K5: Mode groups, channels, axis interchange
6.4 Axis/spindle replacement
6.4.5

Axis transfer to neutral state (release)

RELEASE
Notation in parts program:
RELEASE (axis name, axis name, SPI (Spindle no.), ....)
Note
The axis name corresponds to the axis allocations in the system and is either
• AX1, AX2, AX3, ... or
• the name assigned via the following machine data:
With RELEASE (axis name, ...) a dedicated NC block will always be generated.
Exception: The axis is already in the neutral state.
The RELEASE command is interrupted if
● the prerequisites for axis replacement are not fulfilled
● the axis is involved in a transformation
● the axis is within an axis network.
If ...
the axis is released, but not yet
transferred with GET ...
476
MD10000 $MN_AXCONF_MACHAX_NAME_TAB
(MD20070 $MC_AXCONF_MACHAX_USED and
MD30550 $MA_AXCONF_ASSIGN_MASTER_CHAN)
Note
If the RELEASE command is applied to a gantry master axis, all following axes are
released, too.
and ...
... a RESET takes place via the
operator panel front ...
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
then ...
... the axis is allocated again to
the last responsible channel.
Extended Functions