Programming Of Synchronous Spindle Couplings; Preparatory Programming Instructions - Siemens SINUMERIK 840D sl Function Manual

S3: Synchronous spindle

14.2 Programming of synchronous spindle couplings

14.2 Programming of synchronous spindle couplings
14.2
Table 14- 1
Programmed coupling
Defining a coupling:
COUPDEF(FS, ...)
Activation of a coupling: COUPON(FS, LS, POS
Activate and transfer a movement for coupling difference in speed:
COUPONC(FS, LS)
Deactivation of a coupling: COUPOF(FS, LS, POS
with stop of following spindle: COUPOFS(FS, LS, POS
Deleting the coupling data: COUPDEL
(FS, LS)
Reduced specification without the main spindle
Without specifying a leading axis, the the following language instructions are permitted:
COUPOF(FS), COUPOFS(FS), COUPDEL(FS), COUPRES(FS).
Note
The FS and LS must be programmed for each COUPDEF, COUPON and COUPONC instruction
so that alarm messages are not triggered.
References:
/PGA/, Programming Manual Job Planning, "Synchronous Spindles"
14.2.1

Preparatory programming instructions

Programmable couplings
The number of couplings can be programmed as often as desired depending on the axes
available. This number results from the number of axes/spindles less one for the master.
Furthermore, one coupling can also be configured via machine data as in earlier SW
versions.
Permanently configured coupling
The coupling characteristics and speed ratio for a permanently configured synchronous
spindle coupling can be altered by the NC parts program provided that they are not write-
protected. The machine axes for LS and FS cannot be changed.
892
Overview
Configured coupling(s)
Modification of configured data:
COUPDEF(FS, ...)
)
FS
, POS )
FS LS
)
FS
Reactivating the configured
data: COUPRES (FS, LS)
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Note
Setting the coupling
parameters
Switching on and switching
off
Clearing up, restoring
Extended Functions