Table of Contents
Advertisement
M
1
6
C
2 /
9
G
o r
u
p
9.4 Interrupt Sequence
An interrupt sequence (the device behavior from the instant an interrupt is accepted to the instant the
interrupt routine is executed) is described here.
If an interrupt occurs during execution of an instruction, the processor determines its priority when the
execution of the instruction is completed, and transfers control to the interrupt sequence from the next
cycle. If an interrupt occurs during execution of either the SMOVB, SMOVF, SSTR or RMPA instruction,
the processor temporarily suspends the instruction being executed, and transfers control to the interrupt
sequence.
The CPU behavior during the interrupt sequence is described below. Figure 9.5 shows time required for
executing the interrupt sequence.
(1) The CPU gets interrupt information (interrupt number and interrupt request priority level) by reading
the address 00000
requested).
(2) The FLG register immediately before entering the interrupt sequence is saved to the CPU's internal
temporary register
(3) The I, D and U flags in the FLG register become as follows:
The I flag is cleared to 0 (interrupts disabled).
The D flag is cleared to 0 (single-step interrupt disabled).
The U flag is cleared to 0 (ISP selected).
However, the U flag does not change state if an INT instruction for software interrupt Nos. 32 to 63 is
executed.
(4) The CPU's internal temporary register
(5) The PC is saved to the stack.
(6) The interrupt priority level of the accepted interrupt is set in the IPL.
(7) The start address of the relevant interrupt routine set in the interrupt vector is stored in the PC.
After the interrupt sequence is completed, the processor resumes executing instructions from the start
address of the interrupt routine.
NOTE:
1. This register cannot be used by user.
CPU clock
Address bus
Data bus
RD
(2)
WR
NOTES:
1. The undefined state depends on the instruction queue buffer. A read cycle occurs when the instruction queue
buffer is ready to accept instructions.
2. When the stack is in the internal RAM, the WR signal indicates the write timing by changing high-level to low-level.
Figure 9.5 Time Required for Executing Interrupt Sequence
R
e
. v
1
1 .
2
M
r a
3 .
, 0
2
0
0
7
R
E
J
0
9
B
0
1
0
1
0 -
1
1
2
. Then it clears the IR bit for the corresponding interrupt to 0 (interrupt not
16
(Note)
.
(1)
1
2
3
4
5
Address
Undefined
0000
16
Interrupt
Undefined
information
Undefined
page 79
f o
4
5
8
is saved to the stack.
6
7
8
9
10
11
(1)
SP-2
SP-4
SP-2
(1)
contents
(1)
12
13
14
15
16
vec
vec+2
SP-4
vec
vec+2
contents
contents
contents
9. Interrupts
17
18
PC
Advertisement
Table of Contents
