Power Led Indicator; Power Led Indicator Configuration - Yealink SIP-T5 Series Administrator's Manual

Default 1
Web UI
Features > Notification Popups > Display Forward Call Popup
Parameter features.text_message_popup.enable
It enables or disables the phone to pop up the message when it receives a new text message.
Description
Note: It works only if "features.text_message.enable" is set to 1.
Permitted
0-Disabled
1-Enabled
Values
Default 1
Supported
All phones except CP920
Devices
Web UI
Features > Notification Popups > Display Text Message Popup

Power LED Indicator

Power LED indicator indicates power status and phone status. It is not applicable to CP920 phones.
You can configure the power LED indicator behavior in the following scenarios:
The IP phone receives an incoming call
l
The IP phone receives a voice mail or a text message
l
A call is muted
l
A call is placed on hold or is held
l
The IP phone is busy
l
The IP phone misses a call
l
Topic

Power LED Indicator Configuration

Power LED Indicator Configuration
The following table lists the parameters you can use to configure the power LED indicator.
Parameter phone_setting.common_power_led_enable
Description It enables or disables the power LED indicator to be turned on.
0-Disabled (power LED indicator is off)
1-Enabled (power LED indicator glows red)
Permitted
For T19(P) E2 phones:
Values
0-Disabled (power LED indicator is off)
1-Enabled (power LED indicator glows yellow)
Default 0
Supported
All phones except CP920
Devices
Web UI Features > Power LED > Common Power Light On
Parameter phone_setting.ring_power_led_flash_enable
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Phone Customization
247